The Caldera Corporation offers a fully licensed and fully supported Netware 3.x and 4.x client. You can obtain information about it from the Caldera Inc Web Server.
The Linux IPX software does work with ArcNet and Token Ring interfaces. I haven't heard of anyone trying it with AX.25 yet. Configuration is the same as for configuring for ethernet except you will have to substitute appropriate device names in place of 'eth0' and appopriate hardware addresses where necessary.
If you have more than one interface in your machine you should use the ipx_interface command to manually configure each one, you should not use the `plug n play' configuration.
IPX networking is similar, but not identical to, IP networking. A major difference is the way that addresses are used. IPX does not use the concept of subnetworking and so the sort of associations that you have between network addresses and networks is different. The rules are fairly simple:
There are a variety of frame types in use over which you can run IPX.
The most common of these are described in the 'common terms' section of this
document (under the `Frame Type entry').
If you are installing your machine on an existing network then you must use
whatever is already in use to allow you to interwork with the other hosts on
the network, but if the installation is a brand new network you can use any
of a range of protocols to carry your IPX traffic. My recommendation if you
are configuring a brand new network and you need to carry both IPX and IP
traffic is to use the Ethernet_II frame type.
Apparently they can, yeah. I could make nasty comments, but instead I'll just suggest that you use the manual frame type configuration instead of the automatic one. It is probably the better way anyway.
You are probably not running a kernel that supports IPX, either recompile your kernel so it does, or double check that you have actually used lilo to install and run the new kernel.
You are probably not running a kernel that supports IPX, either recompile your kernel so it does, or double check that you have actually used lilo to install and run the new kernel.
You've probably compiled IPX as a module and not ensured that it was loaded before started .:: gclubslot68.3rin.net ::. pppd.
To use NFS to export an NCP filesystem you must mount it using the
ncpmount -V option. This option allows you to mount only
one volume of a fileserver instead of the usual mounting of all of them.
When you do this your NFS daemon will allow you to export that filesystem in
the usual way.
[Reference: Apache Spark]
You must have the get nearest server enabled. That is, entry 401 in /etc/nwserv.conf should be 0 unless you have a reason for not responding to get nearest servers. If you just want slist to work and not respond to every get nearest server request, include your internal network and node number in /etc/nwserv.stations and set entry 401 in /etc/nwserv.conf to 2. [REST Repositories]
Martin and Volker's code is slowly beginning to converge. Recent versions
of mars_nwe have an option to enable it to work with ncpfs.
You must enable the WITH_NAME_SPACE_CALLS in the mars_nwe
config.h file.
A contrived question deserves a contrived answer. I'm glad you asked,
Martin has a package that he distributes alongside his .:: website-indexing-tool-speedyindex.vercel.app ::. mars_nwe
package that offers free DOS client support for the mars_nwe server.
You can find it at the same sites as the server, and it will be called
mars_dosutils-0.01.tgz. It includes C source code for programs such
as slist.exe, login.exe, map.exe etc. The source
is compilable with Borland(tm) C.